Wireless help

[Mels0n]

I am a complete newbie to linux. I am booting from the cd my hope is that I can knoppix to detect my wireless then I will add some extra apps and remaster the ISO.

lspci looks like this:

00:00.0 Host bridge: ATI Technologies Inc: Unknown device cbb2 (rev 02)
00:01.0 PCI bridge: ATI Technologies Inc PCI Bridge [IGP 340M]
00:06.0 Multimedia audio controller: ALi Corporation M5451 PCI AC-Link Controller Audio Device (rev 02)
00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin IV]
00:08.0 Modem: ALi Corporation Intel 537 [M5457 AC-Link Modem]
00:09.0 Network controller: Broadcom Corporation BCM94306 802.11g (rev 02)
00:0a.0 CardBus bridge: O2 Micro, Inc. OZ6912 Cardbus Controller
00:0b.0 USB Controller: VIA Technologies, Inc. USB (rev 50)
00:0b.1 USB Controller: VIA Technologies, Inc. USB (rev 50)
00:0b.2 USB Controller: VIA Technologies, Inc. USB 2.0 (rev 51)
00:0c.0 FireWire (IEEE 1394): Texas Instruments TSB43AB21 IEEE-1394a-2000 Controller (PHY/Link)
00:10.0 IDE interface: ALi Corporation M5229 IDE (rev c4)
00:11.0 Bridge: ALi Corporation M7101 PMU
00:12.0 Ethernet controller: National Semiconductor Corporation DP83815 (MacPhyter) Ethernet Controller
01:05.0 VGA compatible controller: ATI Technologies Inc Radeon IGP 340M


So I know knoppix can see the device. if i type wlcardconfig it says no wireless network card found.



HELP ME PLEASE

[level]

Are you using Knoppix 3.3?

I believe it has the Prism54 driver on it. Your card is listed on the Prism54 site as being supported. You might want to check this page http://prism54.org/supported_cards.php and the rest of the website for additional information about your card.

[Mels0n]

I am using knoppix 3.3

If the driver where included how would I go about installing my hardware?