Quote Originally Posted by KawaiiDragon
It didn't seem to come with it. but I will try that command and get back to you.

Oh and Im useing a Linksys LNE100TX



__________________________________________________ ___



ok so I tryed that and it says that there isn't a copy of Tulip.o in /lib/modules/2.4.22-xfs/kernel/drivers/net/tulip
That is weird most of the cards I have are tulip and they always work and the module should be included in knoppix what does the output this command grep TULIP /boot/config-2.4.22-xfs in a console window (the shell on a monitor in the taskbar) show you it should look similar to this from my machine.

Code:
HappyTux:/home/stephen# grep TULIP /boot/config-2.4.24.040105
CONFIG_TULIP=m
# CONFIG_TULIP_MWI is not set
# CONFIG_TULIP_MMIO is not set
And you did use lower case letters right not modprobe Tulip but modprobe tulip?


You may want to use lspci -v in the console window to see if the card is getting an irq, what it looks like here.


Code:
HappyTux:/home/stephen# lspci -v
[snip ..]

00:0a.0 Ethernet controller: Linksys Network Everywhere Fast Ethernet 10/100 model NC100 (rev 11)

Subsystem: Unex Technology Corp.: Unknown device d020
        Flags: bus master, medium devsel, latency 64, IRQ 9
        I/O ports at d000 [size=256]
        Memory at dffefc00 (32-bit, non-prefetchable) [size=1K]
        Expansion ROM at dffa0000 [disabled] [size=128K]
        Capabilities: [c0] Power Management version 2
The relevant output of what it looks like when you use lsmod in the console window if the card is in use.

Code:
HappyTux:/home/stephen# lsmod
Module                  Size  Used by
[snip ..]

tulip                  38368  0
crc32                   4096  1 tulip