Hey Guys,
I've been running Knoppix v3.3 at work flawlessly, however at home the OS outputs bad screen image when the GUI loads. What is happening is like when on a regular computer you set a resolution that your monitor can't take and all you see is an unstable shade of the GUI and can barely see the mouse pointer moving, with the only difference that this happens as soon as the GUI loads.

I am not a Pro, however after searching a bit and reading the advanced startup codes, I tried booting specifying:
1- knoppix screen=800x600 (just in case)
2- knoppix toram

...with no luck.

Here are some of the relevant specs from my machine:
Intel 875PBZ Mobo
Intel P4 2.8 HT
1Giga Corsair XMS DDR RAM (can you say "toram"? )
nVidia GeForce FX5950
NEC 1760NX LCD Monitor
Two Hitachi/IBM 80Gb SATA on RAID-0

What I was thinking is that there could be some sort of Driver incompatibility, perhaps I could trow a new driver on a floppy and use a command similar to F6 when you install Windows 2000 that specifies alternate driver usage at boot up?

Any help will be greatly appreciated.

Keep up the great work.

Walter