Customary Information:
Knoppix 3.3 v2.4.22-xfs
Hard drive installed on a 41gig, w/ 500 meg Swap
AMD XP 1700 Proc w/ 512 meg RAM
Modem: Hardware, connected via 9 pin cable to /dev/ttyS0, v90, data/fax
-=- This is what is reported from modem ATI commands, on the mfg of the modem, if pressed, I am sure I can locate the box it came in, but I am sure it was/is a data + fax modem

ATI3 = ACF3_V1.700-V90_P21_FSH
ATI6 = V56DPF-PLL L8571A Rev 47.00/34.00
-=-=-=-=-=-=-

I had to get a fax under the gun, yesterday, and found that only KFax was able to be run as a "inbound" fax program -=- Problem was that I would get the "cover page" stating 7 pages of the fax were total, but only got the cover page -=- examining the "debug" window of activity on KFax, it reported something about "unrecognizable characters", and 1043 lines, but only the single cover page would be listed...

When checking the man pages for KFax, and EFax, and EFix, etc... It appears that these "fax" programs are not very "apparent" if they can receive more than one page...

I threw up my backup computer running Win98, and the exact same fax came in completely, all seven pages, without a problem...

/dev/modem and /dev/ttS0 are linked - both give the same above problem... the modem is a data/fax modem, connected on Seriel Port #1, through a nine pin cable (which came with the modem), and is an external data/fax hardware modem -=- capable of v90 fax communications.

Anyone know of, had same, issues as I am having??? Does anyone do any faxing, both sending and receiving of them, could you recommend any packages to use, or any settings changes to get a resolution of this -=- from what I can tell -=- KFax is only expecting a single sheet on receiving, and drops line before the next page comes through.