Getting airjack to work correctly...

[fenriz]

I'm running a hdd install of knoppix v3.3 and am trying to get airjack to work. So far I've done the following:
I have kernel source
Downloaded and configured pcmcia-cs-3.1.31 (this was the only one I could get it to compile on)
airjack 0.6.2 source (modified the makefile to point to the correct locations)

I can get everything to compile. I run depmod and everything seems fine. When I alter /etc/pcmcia/config to add the airjack device and replace the orinoco_cs driver with airjack_cs for my wlan card everything seems fine.

However when I try to run ifconfig or iwconfig the lappy goes into a race condition and the only way to stop it is to reboot.

Anyone have any ideas?

[level]

You might have better results by e-mailing one of the developers:

http://802.11ninja.net/airjack/

Btw, what are you planning to use with the airjack driver? Do you have the airjack tool set?

[fenriz]

Thanks I'll see what they have to say...

Yes I have the airjack tool set (at least how it was on version 0.6.2).

We're looking at using this as part of an active response within what's becoming a homegrown wireless IDS.

[level]

I've got the 0.6.3 version but it doesn't have the complete set of tools.

Do you have a link for the 0.6.2 version?

[fenriz]

It's a spanish site but anyone should be able to figure it out.

http://valenciawireless.net/weblog/v...ile.php?lid=17

If anyone has sucessfully set this up on Knoppix (not STD) please let me know. I will check with the development folks but based upon the last posts and the status of the site it doesn't look to be supported all that much right now.

[level]

Perhaps as a last resort you might want to try contacting Joshua Wright.

http://home.jwu.edu/jwright/

E-mail address on his web page. He has been active in the airjack project and may be able to give you some help.