Hi everybody!
I am sorry, but my English is very poor. The situation is:

1* - KNX-HD Install
2* - Everything is OK, but when asking DHCP or manual configuration, none works. The installation stops, and a CTRL+C shows the prompt.
I can not continue the installation. DHCP does nothing, manual conf. is not responding...... all I have is an incomplete installation with a prompt.

If I work from CD, during the configuration of the ETH0 says "backgrounding" or something like that. The desktop comes, and everything is OK, but network fails.

I have a W2K DHCP (a previous Debian installation had no problem) and a D-LINK DFE 538 TX PCI network card.

Any ideas?

Thanks a lot from Argentina!

Carlos