-
Monitor settings blow away during boot-up
During boot-up, the text goes flying by and after 'Run level 5', it switches the monitor settings, the screen blanks and comes back a few times, then a colored 'horizontal tearing' screen comes up and there is no way to see anything to try to recover. I made 3 different CDs from 3 sources and they all get the same result, so I suspect the boot-up auto detected wrong, my video setup. (Which is stock on board video- no card) Will any boot option fix it, or are they superceded by autodetection ?
The computer is a stock Pentium 3, 1 ghz IBM, a pVR350 TV card, (Running KnoppMyth just fine on the HD..) and a 200g hard drive.
The setup button on the monitor says it's been switched to 68 hz v and 100 hz h, way higher than usual....
-
Senior Member
registered user
It sounds like knoppix is doing the best it can at autodetecting the video hardware (perhaps getting it wrong) & then setting a resolution & refresh rate that is beyond the capabilities of the hardware. Try booting knoppix with some Cheat Codes, such as:
knoppix screen=800x600 xvrefresh=60
knoppix screen=640x480 xvrefresh=60
I hope this helps.
James
Similar Threads
-
By joepayne in forum Hardware & Booting
Replies: 4
Last Post: 06-05-2007, 10:29 PM
-
By ultramagneus in forum General Support
Replies: 2
Last Post: 01-30-2005, 05:50 PM
-
By CCC-Shiner in forum General Support
Replies: 1
Last Post: 12-04-2004, 08:24 AM
-
By Valent in forum General Support
Replies: 2
Last Post: 07-02-2004, 01:48 AM
-
By Cuddles in forum General Support
Replies: 21
Last Post: 05-03-2004, 08:07 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Vintage 5362 IBM System/36 Mini-Computer Mainframe 5291 2, CRT Terminal DM12N501
$219.99
Compaq Portable II Computer
$125.00
Digital DEC LK201 Terminal Keyboard RJ11 Connection Mainframe
$49.00
Vintage Silicon Graphics SGI Indy B006 Workstation Computer
$149.95
Atari TT030 Computer - New In box never Used
$4000.00
VINTAGE CPU IBM MCM POWER7 - MAINFRAME PROCESSOR
$49.00
IBM Mainframe Vintage MVS/XA DFP V2 R3 Microfiche (~ 300K pages on ~800 cards)
$80.00
GMK Awaken - Mainframe base kit (BNIB - Factory Sealed)
$100.00
Apple Macintosh LC III Pre Owned Not Tested
$199.95
Unisys Mechanical Clicky Keyboard AT/XT PN:F4208-00 Mainframe Collection
$339.99