Network-Manager is a daemon that listens to interfaces statuses and selects a configuration based on wireless SSIDs or user interaction. It is not a graphical program by itself, but interacts with graphical user interfaces for control, as well as featuring a tiny commandline interface and controls over dbus, so it is quite flexible. By default, network-manager does a lot on its own, like trying DHCP as soon as you plug in a cable into the network card.
Actually, network-manager should respect manual settings in /etc/network/interfaces, also in textmode. In fact, Knoppix contains a script that changes network-managers configuration entirely via /etc/network/interfaces for use in textmode:
"knoppix-networkmanager".
However, after changing /etc/network/interfaces manually, you need to restart network-manager in order for changes to take effect:
sudo /etc/init.d/network-manager restart
Do NOT use ifup/ifdown if network-manager is running. Network-manager will ignore the lock status of ifup/ifdown, while ifup/ifdown will ignore all settings done with network-managers own control programs.
Using static IP addresses in network-manager works fine as long as there is a physical connection, but unfortunately, network-manager does not seem to keep the set IP address when there is no carrier signal on the network cable.
If you want to use the command-line, you have the option of excluding an interface from being handled by network-manager:
sudo nmcli dev disconnect iface eth0
which makes network-manager stop listening on eth0 at all, so you can work with ifup/ifdown again if you are more used to these.
Or just suspend network-manager:
sudo /etc/init.d/network-manager stop
(which is an alternative to using the "nonetworkmanager" cheatcode in Knoppix).
Because of its user-friendly desktop integration in Gnome and KDE (and LXDE, too), most distros are using network-manager by default nowadays. For commandline experts who are used to configure everything manually via ifconfig and route, it's a little uneasy that a daemon is handling all the network stuff and will override manual settings (except in the aforementioned cases), I agree with that. So I would recommend just booting Knoppix with the "nonetworkmanager" option, or use the tricks above to revert to the non-automatic configuration behaviour.
Regards
-Klaus
SAS - HGST Ultrastar 7K4000 HUS724040ALA640 0F14688 3.5" 4TB 7.2K RPM 64MB HDD
$19.99
HITACHI HUS724040ALA640 4TB 7200RPM 64MB SATA 6.0Gb/s 3.5" HARD DRIVE ZERO HOURS
$52.00
Western Digital Gold Enterprise 4TB,7200 RPM Internal Hard Disk Drive WD4002FYYZ
$39.95
Seagate ST1000VM002 1TB 64MB SATA6Gb/s 3.5" (Low Power) Hard Drive -PC, CCTV DVR
$24.99
HGST Ultrastar DC HC520 12TB SATA 6Gb 256MB 3.5" Enterprise HDD- HUH721212ALE601
$74.99
Seagate ST12000NM0127 12TB SATA 6Gb/s 256MB 7200RPM 3.5" Enterprise Hard Drive
$99.99
1TB HDD/SSD 2.5" SATA Hard Drive with Windows 10 or Windows 11 Pro Installed
$18.99
Seagate Exos X20 18TB SATA 6Gb/s 3.5" Enterprise Hard Drive - ST18000NM003D
$168.00
Western Digital 4TB Internal 7.2KRPM 3.5" (WD4000FYYZ) SATA Hard Drive ZERO HOUR
$89.99
Seagate ST8000NM0055 8TB 7200RPM 256MB SATA 6.0 Gb/s 3.5" Enterprise Hard Drive
$34.30