Have a look at "Check the ISO" and also try the cheatcode "knoppix testcd"
I have a Dell Latitude Laptop that I have been running Zorin (Ubuntu derivitive) on. I just installed Knoppix from Flash drive and it went well and I was able to boot yesterday. I now booted up today and I get to where it says INIT: Entering runlevel: 5 and freezes. I am sitting at the root@Microknoppix:/#_ the underscore blinks for a few mins then stops and now I'm frozen.
Any help would be greatly appreciated.
Thanks
Have a look at "Check the ISO" and also try the cheatcode "knoppix testcd"
It;s installed on the hard drive. booted it two or three times then the next morning it wouldn't boot.
Ok, but what is about "check the ISO" and "knoppix testcd" with the Knoppix DVD/CD you've downloaded and used for HD installation? And what type of installation have you done: "HD Install" or "Flash Install to HD"?
Last edited by Werner P. Schulz; 05-09-2013 at 05:48 PM.
Cisco SFP-10G-T-S 10GBASE-T SFP+, 30m@Cat6a/Cat7, Copper, RJ45
$83.99
Cisco SFP-10/25G-CSR-S 10/25GBASE-CSR SFP28, 850nm, 100m, LC,
$54.00
Cisco SFP-10G-BX40D-I 10GBASE-BX-D BiDi SFP+, 1330nm-TX/1270nm-RX, 40km, LC, SMF
$59.99
Cisco GLC-TE 1000BASE-T SFP, 100m, Copper, RJ45
$27.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
Lot of 10 - HP 10Gb SR SFP+ Transceiver 455883-B21 455885-001 456096-001 850nm
$23.99
Juniper Networks EX3300-48P 48-Port PoE+ 4x SFP+ Network Switch w/ Power Cord
$43.95
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00