Have a look at "Check the ISO" and also try the cheatcode "knoppix testcd"
I have a Dell Latitude Laptop that I have been running Zorin (Ubuntu derivitive) on. I just installed Knoppix from Flash drive and it went well and I was able to boot yesterday. I now booted up today and I get to where it says INIT: Entering runlevel: 5 and freezes. I am sitting at the root@Microknoppix:/#_ the underscore blinks for a few mins then stops and now I'm frozen.
Any help would be greatly appreciated.
Thanks
Have a look at "Check the ISO" and also try the cheatcode "knoppix testcd"
It;s installed on the hard drive. booted it two or three times then the next morning it wouldn't boot.
Ok, but what is about "check the ISO" and "knoppix testcd" with the Knoppix DVD/CD you've downloaded and used for HD installation? And what type of installation have you done: "HD Install" or "Flash Install to HD"?
Last edited by Werner P. Schulz; 05-09-2013 at 05:48 PM.
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco w/ Green Hologram SFP-10/25G-LR-S 10/25GBASE-LR SFP28 Transceiver Module
$79.99
Cisco Meraki MA-SFP-10GB-SR 10G SFP+ SR 850nm 300m LC MMF
$29.99
Cisco w/ Green Hologram GLC-SX-MM-RGD 1000BASE-SX SFP Transceiver Module
$19.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Lot of 10 SFP-GB-GE-T Copper RJ45 10/100/1000Base-T 100m Transceiver Modules
$29.94
Genuine Cisco QSFP-40G-SR-BD 10-2945-02 Transceiver Module
$15.00
LOT OF 20 Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module
$89.00
New Cisco w/ Green Hologram SFP-25G-SR-S 25G SFP28 SR 850nm 300m LC MMF Module
$69.99