Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Commodore SX-64 Vintage Portable C64 Computer With Original Box RARE
$1200.00
Commodore 1541-ii Disk Drive, Power Supply, Serial Cable, Box Read Description
$69.99
Used Cardboard 6 Expansion Interface For Commodore VIC-20 w/ Manual *Untested US
$74.99
Commodore 264 Series Model 16 (F2)
$89.99
Vintage Commodore 64C Computer Matching #'s w/Power Supply & Box Works C64 C-64
$172.00
$235.00
Commodore 64C Computer With Power Supply Works C64 C-64
$162.55
TeensyROM Cartridge for Commodore 64/128: MIDI, Fastload, Emulation, and Network
$65.00
Vintage COMMODORE 64 PERSONAL COMPUTER *Has No Output*
$149.99