Hello,
I'm booting a board with 7.7.1
This board has 3 DVI display ports, one of them is converted to VGA by hardware.
The board has only one graphic card.
After booting, I can see few boot messages on the VGA output and then, the screen is black.
The display probably goes to another port.
How can I specify the required port in knoppix ?
Thank you,
Zvika
Altair 8800 CPU Board Working *TESTED* reproduction
$790.00
$4850.00
S100 Card Connectors for IMSAI, Altair etc.
$10.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$8900.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$69.95
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS Altair Package II on Punched Paper Tape
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$358.99
Wenger laptop backpack, Altair, 15.6 inch, tablet compartment, Black
$140.24