Check out the Cheat Codes for optional bootup switches.
http://knoppix.net/wiki/Cheat_Codes
I have a 64-bit processor on a Dell 9360 machine.
If I boot into Knoppix 8.2.0 Live from a portable drive and run simple queries as follows I get:
$ lscpu
Architecture: x86_64
CPU op-mode(s): 32 bit,64 bit
Flags: ... lm ...
$ lshw -C processor | grep width
width: 64 bits
$ grep flags /proc/cpuinfo | grep " lm "
Flags: ... lm ...
which all confirm the 64-bit architecture. BUT the response
CPU op-mode(s): 32 bit,64 bit
apparently indicates that I am running a 64-bit-capable machine in 32-bit-mode.
Yes? - is this a true interpretation?
My /boot/isolinux/isolinux.cfg file contains the lines (omitting redundant qualifiers for ease of reading)
DEFAULT fergus
LABEL fergus
KERNEL ifcpu64.c32
APPEND knoppix64 -- knoppix
APPEND knoppix64
LABEL knoppix
KERNEL linux
APPEND initrd=minirt.gz
LABEL knoppix64
KERNEL linux64
APPEND initrd=minirt.gz
which I hoped meant "if 64-bit machine use 64-bit OS; if 32-bit machine use 32-bit OS" but apparently not.
How can I tweak the isolinux.cfg file to behave as required one line up?
Thank you!
PS1 I have to admit (I have only just noticed) that the file ifcpu64.c32 referred to above is very suggestive of an instruction "if 64-bit machine use 32-bit OS". Is that what it achieves, and the cause of the mismatch described?
PS2 I use this ifcpu file from the Knoppix 7.4.2 provision. I find the Knoppix 8.2.0 version stops Knoppix stone dead before it even starts. It simply does not work, at all. Anybody else?
Check out the Cheat Codes for optional bootup switches.
http://knoppix.net/wiki/Cheat_Codes
Cisco Catalyst C9300-24UX-A 24 Port 10G/mGig UPOE Network Switch, no module
$349.97
Cisco Nexus N9K-C92160YC-X 48P 25GbE SFP28 6P QSFP+/QSFP28 PE Switch
$475.00
Cisco Nexus 9300 48-Port 25GbE SFP 6x100GbE QSFP Switch P/N: N9K-C93180YC-EX
$499.99
CISCO DS-SFP-FC64G-SW Sealed Hologram New
$200.00
GENUINE Cisco SFP-10G-SR V03 SFP+ GBIC Transceiver Module 10-2415-03
$6.80
Cisco Nexus N3K-C3064PQ-10GX 48P 10GbE SFP+ 4P QSFP+ Switch (Fair)
$85.00
Cisco C3850-NM-2-10G 2 Port Network Exp.Module for 3850
$30.99
C9300-NM-8X CISCO Catalyst 9300 8 x 10GE Network Module
$235.80
Cisco ASR 901 Aggregation Services Router A901-12C-FT-D
$59.99
Cisco Nexus N9K-C9372TX 48P 10G Gigabit Ethernet 6x QSFP+ 40G Switch 2x650W PSU
$199.99