Check out the Cheat Codes for optional bootup switches.
http://knoppix.net/wiki/Cheat_Codes
I have a 64-bit processor on a Dell 9360 machine.
If I boot into Knoppix 8.2.0 Live from a portable drive and run simple queries as follows I get:
$ lscpu
Architecture: x86_64
CPU op-mode(s): 32 bit,64 bit
Flags: ... lm ...
$ lshw -C processor | grep width
width: 64 bits
$ grep flags /proc/cpuinfo | grep " lm "
Flags: ... lm ...
which all confirm the 64-bit architecture. BUT the response
CPU op-mode(s): 32 bit,64 bit
apparently indicates that I am running a 64-bit-capable machine in 32-bit-mode.
Yes? - is this a true interpretation?
My /boot/isolinux/isolinux.cfg file contains the lines (omitting redundant qualifiers for ease of reading)
DEFAULT fergus
LABEL fergus
KERNEL ifcpu64.c32
APPEND knoppix64 -- knoppix
APPEND knoppix64
LABEL knoppix
KERNEL linux
APPEND initrd=minirt.gz
LABEL knoppix64
KERNEL linux64
APPEND initrd=minirt.gz
which I hoped meant "if 64-bit machine use 64-bit OS; if 32-bit machine use 32-bit OS" but apparently not.
How can I tweak the isolinux.cfg file to behave as required one line up?
Thank you!
PS1 I have to admit (I have only just noticed) that the file ifcpu64.c32 referred to above is very suggestive of an instruction "if 64-bit machine use 32-bit OS". Is that what it achieves, and the cause of the mismatch described?
PS2 I use this ifcpu file from the Knoppix 7.4.2 provision. I find the Knoppix 8.2.0 version stops Knoppix stone dead before it even starts. It simply does not work, at all. Anybody else?
Check out the Cheat Codes for optional bootup switches.
http://knoppix.net/wiki/Cheat_Codes
Cisco GLC-FE-100FX-RGD 100BASE-FX SFP Transceiver Module
$17.99
Lot of 10pcs Brocade 57-1000012-01 8Gbps SWL 850nm SFP+ Optical Transceivers
$19.00
Cisco Meraki MA-SFP-1GB-SX 1000BASE-SX SFP Transceiver Module
$24.99
Cisco Meraki MA-SFP-10GB-SR 10G SFP+ SR 850nm 300m LC MMF
$29.99
Genuine Cisco SFP-10G-SR V03 10GBASE-SR SFP+ Transceiver Module 10-2415-03
$8.00
SFP-10G-SR Original Cisco 10GBASE-SR SFP+ V02 Multi mode Transceiver 10-2415-02
$5.00
Brand New Cisco GLC-LH-SMD 1000BASE-LX/LH SFP Module 1310nm 10km SMF LC
$13.89
10Gbps 10GB SFP+SR transceiver for UniFi Switch 16 XG 16port Ubiquiti US-16-XG
$10.99
10 PCS Cisco GLC-LH-SMD 10-2625-01 1310nm SFP Transceiver Module
$85.00
New HP HPE Aruba J9150D 10G SFP+ LC SR 850nm 300m MMF XCVR Transceiver Module
$49.99