Please try
knoppix nopcmcia ide2=0x180,0x386
at the boot prompt. I tested it with Sony Vaio notebooks with external PCMCIA CD drive.
trying to install knoppix on an old laptop (ACER Extensa 355 ) , it only has a floppy drive and a PCMCIA ( I thnk it's TI 1131 Cardbus controller ) cd-rom errors i get are :
cannot allocate resource region 1 of device 00:0c.0
then the welcome too knoppix line, then :
dropping to (very limited shell) ...etc
when i try mount it reports :
FAT: bogus logical sector size 5120
FAT: bogus logical sector size 5120
Kernel Panic:VFS: unable to mount root fs on 01:01
any ideas (other than smartass 'buy a new laptop' :op )
Please try
knoppix nopcmcia ide2=0x180,0x386
at the boot prompt. I tested it with Sony Vaio notebooks with external PCMCIA CD drive.
no joy :o(
same errors, no change at all
You could try booting in "expert" mode, it will ask you what should be loaded. I guess you will be asked some linux "inside" questions too, so...Originally Posted by Yakumo
...Could be helpfull, could be not.
You did press F2 to enter the cheatcodes I hope?
Vintage 1960s Donner Model 3000 Analog Computer ~ MUSEUM PIECE Extremely Rare
$4000.00
NEC Multisync II JC-1402HMA VGA EGA CGA Analog TTL Computer Monitor Vintage 1988
$699.99
NEW Aquarius+ Computer Signature Edition - 8Bit Retro System
$239.00
Macintosh SE/30 M5119 Computer 20MB RAM 1.2GB Hard Drive Recapped Working *Read*
$500.00
Landen Computer. Circa 1898. the Rapid Computer Company. With Original Case.
$425.00
IBM Modem Saver Phone Line Tester
$7.99
Macintosh Classic/Classic II Analog Board Computer 630-0395 New
$270.00
Burr Brown Analog Computer parts Circuit boards w Helipot Potentiometers 1631a
$85.00
Extron RGB-160XI Analog Computer Video 60-378-01
$199.00
Wooting Two HE Mechanical Keyboard Analog Linear Lekker Switches
$299.99