Hi,
Just a few notes here about the installation of Knoppix 7.2.0 on an old EEEPC 701 (512 Mo RAM, 4 Go SSD, 800x480 screen).
Works OK, wifi OK. But installation to hard disk (SSD in fact) was painful because of the restrictions and lack of configurability of KNOPPIX "0wn" script. For successful use of the "0wn" script I did the following:
* Modify /usr/share/0wn/0wn-partitioning so that fonction get_disks() only returns "/dev/sda" (the result normally includes /dev/sdc, which causes a bug on my machine because /dev/sdc is not available)
* Reduce swap size in function partition_whole_disk() in script /usr/share/0wn/0wn-partitioning
* Reduce SWAP_NEEDED value accordingly in script /usr/share/0wn/0wn-common
After this, the "0wn" script could run flawlessly and installation finished correctly. Last configuration was to set "xmodule=fbdev" in the boot command line, in order to get the 800x480 screen resolution working.
O.
Vintage 1960s Donner Model 3000 Analog Computer ~ MUSEUM PIECE Extremely Rare
$4000.00
NEC Multisync II JC-1402HMA VGA EGA CGA Analog TTL Computer Monitor Vintage 1988
$699.99
NEW Aquarius+ Computer Signature Edition - 8Bit Retro System
$239.00
Landen Computer. Circa 1898. the Rapid Computer Company. With Original Case.
$425.00
IBM Modem Saver Phone Line Tester
$7.99
Burr Brown Analog Computer parts Circuit boards w Helipot Potentiometers 1631a
$85.00
Apple IIc Analog Board NOS - 661-0265
$74.00
Vintage Apple Macintosh Plus Completely Recapped #M0001A 1MB
$649.95
Extron RGB-160XI Analog Computer Video 60-378-01
$187.06
Sony Trinitron CPD-1304 9 PIN Analog Vintage CRT Monitor - Great for Retro PC
$475.30