-
init: must be run as PID 1
Running Knoppix from a boot USB stick:
My preference is not the default start mode (X) but at the plainest possible bash console.
By editing syslinux.cfg appropriately I've been able to manage this since about v.3!
For the moment in this version (v.9.1) this trick eludes me - I'll try again later.
So, I'm trying another pathway that has worked in the past.
In the root terminal in X (i.e. as root) type
$ init 1 <Enter>
and Hey Presto I am out of X, but still logged in as root, and at the plain bash console.
BUT: now the "init 1" request results in this message:
init: must be run as PID 1
and I am still in X.
So: please can anybody
(a) supply a tweaked syslinux.cfg that starts KNOPPIX in ultra-basic mode?
or (b) supply a workaround that will permit init 1 if started in X mode?
or (ideally) both??
Thank you.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Vintage 1960s Donner Model 3000 Analog Computer ~ MUSEUM PIECE Extremely Rare
$4000.00
NEC Multisync II JC-1402HMA VGA EGA CGA Analog TTL Computer Monitor Vintage 1988
$699.99
NEW Aquarius+ Computer Signature Edition - 8Bit Retro System
$239.00
Macintosh SE/30 M5119 Computer 20MB RAM 1.2GB Hard Drive Recapped Working *Read*
$475.00
Landen Computer. Circa 1898. the Rapid Computer Company. With Original Case.
$425.00
IBM Modem Saver Phone Line Tester
$7.99
Burr Brown Analog Computer parts Circuit boards w Helipot Potentiometers 1631a
$85.00
NEW Aquarius+ Mini 8Bit Retro Computer System - Assembled PCB ONLY
$109.00
Extron RGB-160XI Analog Computer Video 60-378-01
$187.06
Macintosh Classic/Classic II Analog Board Computer 630-0395 New
$270.00