I'm so used to hitting CTRL+ALT+t to start up a terminal, here's how to do it in knoppix 9.1.
Go to Preferences/CompizConfig Settings Manager then click on General / Commands, set command line 1 to "terminator" (don't type the quotes) then go to Key Bindings and set "Run command 1" to Control Alt t by clicking on the "disable button" (because it's disabled by default) and then click on "grab key combination" and type Control Alt t and then click on OK.
Now Control Alt t should load terminator.
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$69.95
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
New Unused S-100 Bus Edge Card Connector Vintage Altair Imsai Computer
$74.99
IMSAI 8080A MPU-A CPU Parts Kit Not Altair MITS (board NOT included)
$59.95
Vintage NorthStar Horizon HRZ HD-5 Hard Drive Controller 1978 S-100 IMSAI Altair
$125.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
HyperWorks 2020 Suite for PC (Tool For Engineering Design, Simulation) 50Gb
$72.87
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$358.99