I run Linux on my desktop at home and I have a wireless card built in. I successfully managed to configure the wireless card and even got air snort working. However on my laptop when I boot up knoppix it detects my wireless card but has a problem with my wep key. This is what I do:
1. Go to root command
2. Wlcardconfig
3. Put in my network id
4. Put in my wep
5. Type pump -i eth0
That’s when the operation fails
When I go over to my friends house who has no wep key on his wireless router everything works fine with knoppix so there is no compatibility problems or hardware problems. However I also have a problem with air snort. For some reason it gives me an error about monitor mode or something like that. Can anyone help?
Vintage 1960s Donner Model 3000 Analog Computer ~ MUSEUM PIECE Extremely Rare
$4000.00
NEC Multisync II JC-1402HMA VGA EGA CGA Analog TTL Computer Monitor Vintage 1988
$699.99
Macintosh SE/30 M5119 Computer 20MB RAM 1.2GB Hard Drive Recapped Working *Read*
$500.00
NEW Aquarius+ Computer Signature Edition - 8Bit Retro System
$239.00
Landen Computer. Circa 1898. the Rapid Computer Company. With Original Case.
$425.00
IBM Modem Saver Phone Line Tester
$7.99
Apple IIc Analog Board NOS - 661-0265
$74.00
Burr Brown Analog Computer parts Circuit boards w Helipot Potentiometers 1631a
$85.00
Extron RGB-160XI Analog Computer Video 60-378-01
$187.06
Macintosh Classic/Classic II Analog Board Computer 630-0395 New
$276.00