When my brother was describing his Tesla to me one of the this he told me about it is that is remembers the seat position, screen layout, etc depending on his key, or his wife's, being inserted.
Yet Knoppix does not remember the cheat codes entered when you save it's config. When you save a systems configuration, it must include things like screen preference, time zone, etc, i.e. things that are set on Knoppix via cheat codes.
I use a cd formatted usb, i.e. no changes, for system testing, etc (my tool bag contains versions 3.?, 5.1.1, 7.2 and latest).
I would like to use a similar usb, but with my preferred screen resolution, time zone and a few browser bookmarked sites, for banking - and i would prefer that usb to be "cd" formatted too for security. Why can't i create a read only usb, after i've saved some bookmarks, that remembers my preferred screen settings & tz?
p.s.
It's ok if it can't remember my seat settings.
Last edited by Marv; 09-08-2018 at 05:46 PM.
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$69.95
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
IMSAI 8080A MPU-A CPU Parts Kit Not Altair MITS (board NOT included)
$59.95
New Unused S-100 Bus Edge Card Connector Vintage Altair Imsai Computer
$74.99
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
1975 MITS ALTAIR USERS GROUP COMPUTER NOTES MAGAZINE VOL 1, ISSUE 2 GATES ALLEN
$449.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
HyperWorks 2020 Suite for PC (Tool For Engineering Design, Simulation) 50Gb
$72.87
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00