Thanks for the reply! I've tried a few different things and it doesn't seem like my wireless connection is quite making it

When I iwconfig I get:

ath0 IEEE 802.11 ESSID:"dlink"
Mode:Managed Frequency:2.437GHz Access Point: 00:0F:3D:3E:FB:10
Bit Rate:36Mb/s Tx-Powerff Sensitivity=0/3
Retryff RTS thrff Fragment thrff
Encryption keyff
Power Managementff
Link Quality:23/94 Signal level:-72 dBm Noise level:-95 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

and when I ifconfig

ath0 Link encap:Ethernet HWaddr 00:0F:3D:50:13:51
inet addr:192.168.0.101 Bcast:192.168.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2337 errors:1013 dropped:0 overruns:0 frame:1013
TX packets:44 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:199
RX bytes:268190 (261.9 KiB) TX bytes:4205 (4.1 KiB)
Interrupt:17 Memory:e0c71000-e0c81000


I am able to "ifconfig ath0" up yet when I try to "pump -i ath0" I recieve "Operation failed" (I'm also unable to ping my gateway). It seems that my AP is being detected, along with the bit rate, link quality, as well as signal and noise levels.
ifconfig detects my router assigned ip address and seems to show alot of errors. I'm very curious as to what's causing this

If you need any additional info please don't hesitate to ask.
Anything you can gather from this would help

Thanks again!