I have two separate hdd's. one for my knoppix installation and one for my windows installation. the windows hdd is the master and linux is on the slave drive. i installed knoppix 3.6 and it seemed to install fine. i can access all the partitions from knoppix without a problem. however, thats not the case for windows. when i go to windows, obviously, the system partition shows up fine. thats not the case for the other two partitions though. they don't show up as a drive. i can see the two partitions under the disk management mmc though. the partitions show up as healthly ntfs partitions and i can even see the name of the partition that i had originally assigned to it. there just isn't a drive letter assigned to the two partitons anymore. i guess what i'm asking, in a sense, is how can i remount my windows partitions? this might not be the right place to ask that question but the question that is appropriate for this thread is what does the knoppix installer do during installation that could have possibly corrupted my windows partition table? oh, btw, i installed lilo to my mbr as my boot manager, but i didn't think that any partition information is saved to the mbr. thanks in advance for anyone that can help me.