Hi James,

I did as you instructed - modprobe 8139too then ifconfig -a then netcardconfig.

Here is the results:

Code:
eth0      Link encap:Ethernet  HWaddr 00:50:FC:FE:FD:47
          inet addr:192.168.0.1  Bcast:192.168.0.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:5 Base address:0xc000Hi James,

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:10 errors:0 dropped:0 overruns:0 frame:0
          TX packets:10 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
By the way - after running ifconfig -a I still was not able to load a web page. However it seems like some signal is getting through. In other words - the browser takes a while before letting me know that it can't connect. Before running your commands when I tried using the browser it immediatly told me there was not a connection. Is this helpful?