good idea, most should be possible w/o remastering by simply changing the configs, but:
why the extra external adsl router? Knoppix can do that as well
How about a superserver.
I have tried over many nights to create this monstrosity, but so far not much luck.
A 3 interface box with an ethernet ADSL router, Wireless access point, and my home network.
Use knoppix Terminal server for internal net-boot clients (just dhcp for windows), and Samba server.
use dyndns and ddclient to tell me where it is when away from home.
frees/wan for WiFi access when at home on my notebook.
bind resolving my internal ip's and forwarding to the proxy on my adsl router.
tranparent squidcache to service redirects from iptables. (fwbuilder?)
getmail, gotmail, and yosucker to get my mail.
mrtg to keep my ISP honest. (Have an issue with them at the moment, They have been metering at least 25% more than what my router shows)
imp to serve my mail via apache https when away from home.
from internet terminate ssh, https, ipsec-vpn (with nat traversal)
So far have only ddclient, and getmail working. Now stuck on imp.
good idea, most should be possible w/o remastering by simply changing the configs, but:
why the extra external adsl router? Knoppix can do that as well
Any method would be good.
I just happen to have an external router.
Perhaps even supporting diald? This may limit external access though?
and not to forget webmin
Haven't had much success with webmin.
Installed it on two separate HPUX boxes. And played with it for a few minutes on each. But got very difficult once I tried to do anything serious with it.
Ended up using vi![]()
For my experience, I use knoppix as a workstation, and e-smith for my home server.
I also use e-smith for the server, but having all of the above done with Knoppix would also be fine. As for webmin, I was able to install it on my home directory (which resides on HD) without any problems.
e-smith looks interesting. Does it run from cd?
No it needs a hd, I think the current versions will need about a 1GB hd, it is hardcoded for a 256MB swap and needs about 300-400mb for the OS.e-smith looks interesting. Does it run from cd?
I've still been using earlier versions because I can get them to run on older hardware with a 500mb hd.
E-smith is a full featured gateway/server package, for internet sharing and file and print sharing, it is very easy to set up, but kind of slow as far as the web interface goes.
rock
Thanks.
I'll think I'll stick with trying to get this stuff to go on knoppix just for the moment.
Have got imp going finally![]()

DEC PDP-11/34 Front Panel Complete PDP11 RARE
$450.00
Vintage Intel Mainframe Server MCM CPU Substrate Lot Prototyping PGA Validation
$500.00
HP 5060-8359 8K Semiconductor Memory Module 5080-9747 Vintage HP Computer
$224.72
HP 13210-60001 Disc Drive Interface PCB HP 7900A 7901A Vintage
$225.61
Vtg IBM Mainframe Prototype Chip Module Lot 146 pc 1988-1993 ES/9000 Lab Arcive
$649.00
Vintage Mainframe Computer Disk Drive Pack Dyson SMD 5 Level Disks
$79.00
Computer Tape Reel 1600 BPI 9 Track Vintage Mainframe LOT OF 2 WITH BOX
$89.95
Commodore 64 PC with Model 1541 Diskette Drive and Flight Simulator II *READ*
$199.99
Vintage Telex 952003-112 Mechanical Terminal Keyboard IBM 3270 Mainframe DB25
$799.00
IBM 3274-51C Controller 3270 mainframe 8" floppy tested to power on
$500.00