cannot connecting to NIC -installed to HD-

[buzzlyhan]

Hi, all. I am a newb.

I installed kmoppix 5.11.
It can connect to NIC by CD-ROM start, but it cannot connect that HD installed and start.

computer:
SONY VAIO PCG-QR1E/BP
Ethernet Driver (Intel815EM) 5.40.11.0000 （EtherDrv_54011_WMe.exe）（344KB）［2001/07/31］
Modem Driver (Conexant SmartMC II) 2.14.18-010321 （Modem_21418_WMe.exe）（1,580KB）［2001/07/31］

Follows are CD booting.
eth1 Link encap:Ethernet HWaddr 08:00:46:20:7E:25
inet addr:192.168.11.4 Bcast:192.168.11.255 Mask:255.255.255.0
inet6 addr: fe80::a00:46ff:fe20:7e25/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:22 errors:0 dropped:0 overruns:0 frame:0
TX packets:22 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3384 (3.3 KiB) TX bytes:4234 (4.1 KiB)

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:18 errors:0 dropped:0 overruns:0 frame:0
TX packets:18 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:900 (900.0 b) TX bytes:900 (900.0 b)

I hope helps, Thanks.

[Harry Kuhman]

It can connect to NIC by CD-ROM start, but it cannot connect that HD installed and start.

Yup, a very common problem, and the reason many of us say that Knoppix isn't suitable for hard disk install. Please see answer #2.

[buzzlyhan]

Thank you for your advice!

I overlooked the wiki info.