I am running Knoppix HDD Installation

I am attempting to install a D-Link AirPlus G DWL-G630 REV: E1.

This is not shown on the american D-Link website, as i am currently an australian citizen... I have tried madwifi, and other's but none have seem to of worked, any help is appreciated.

(from dmesg | tail)
eth0: no IPv6 routers present
pccard: card ejected from slot 0
ACPI: PCI interrupt for device 0000:02:00.0 disabled
eth0: Media Link Off
pccard: CardBus card inserted into slot 0
PCI: Enabling device 0000:02:00.0 (0000 -> 0002)
ACPI: PCI Interrupt 0000:02:00.0[A] -> GSI 19 (level, low) -> IRQ 16
PCI: Setting latency timer of device 0000:02:00.0 to 64
wmaster0: Selected rate control algorithm 'simple'
rt61pci->rt61pci_init_firmware_cont: Error - Failed to load Firmware.
(from lspci -v)

02:00.0 Network controller: RaLink RT2561/RT61 rev B 802.11g
Subsystem: D-Link System Inc DWL-G630 Rev E
Flags: bus master, slow devsel, latency 64, IRQ 16
Memory at 22000000 (32-bit, non-prefetchable) [size=32K]
Capabilities: [40] Power Management version 2


[/quote]

When it is plugged in its lights flash then it turns off permanently, i am currently on wired to post this message.

any help is greatly appreciated