try
mii-tool -F 100baseTx-FD
( mii-tool --help for help )
Just installed knoppix 3.3 on my hard drive. I noticed during boot up that my network card (eth0) is configured to use 100Mbps half-duplex. Could anyone please tell me how i could change this to 100Mbps full-duplex?
Thank you
try
mii-tool -F 100baseTx-FD
( mii-tool --help for help )
thanks alot that did it.

Vintage Intel Mainframe Server MCM CPU Substrate Lot Prototyping PGA Validation
$500.00
HP 13210-60001 Disc Drive Interface PCB HP 7900A 7901A Vintage
$225.61
HP 5060-8359 8K Semiconductor Memory Module 5080-9747 Vintage HP Computer
$224.72
Vintage Telex 952003-112 Mechanical Terminal Keyboard IBM 3270 Mainframe DB25
$799.00
Vintage Mainframe Computer Disk Drive Pack Dyson SMD 5 Level Disks
$79.00
Commodore 64 PC with Model 1541 Diskette Drive and Flight Simulator II *READ*
$199.99
Vtg IBM Mainframe Prototype Chip Module Lot 146 pc 1988-1993 ES/9000 Lab Arcive
$649.00
Rare Vintage Mainframe Burroughs Discrete-Transistor Cordwood Module B2500/B5000
$99.95
Vintage UNIVAC 3620670-01 Mainframe Logic Board 15MHz Sperry Computer PCB
$98.95
IBM 3274-51C Controller 3270 mainframe 8" floppy tested to power on
$500.00