boot from cd, save the /etc/X11/XF86config-4 file, and compare it with your hd-install - XF86... -file.
Use diff or kdiff.
diff file1 file2 | less
replace the hd- with the cd-file.
I have installed knoppix by knx-hdinstall, but it doesnt work properly. After it enters init 5 level, my screen just start flickering. Is that a problem of resolution ?? How do I overcome this? I had also installed Knoppix with same CD but at that time everything was working fine. Are there any options I need to give while installing knoppix on harddisk
boot from cd, save the /etc/X11/XF86config-4 file, and compare it with your hd-install - XF86... -file.
Use diff or kdiff.
diff file1 file2 | less
replace the hd- with the cd-file.
MITS Altair 680 Case Only LAST ONE LS3
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00