Hallo,
ich habe Knoppix 3.7 auf einem Gericom Supersonic GPRS installiert. Es gibt mehrere Probleme, das zentralste ist folgendes:
Die Netzwerkkarte (die unter der parallelen Windows XP Partition weiterhin problemlose läuft, also nicht defekt ist), ist "deaktiviert". Das Knoppix Infocenter liefert folgende Meldung:
Ethernet controller: Accton Technology Corporation EN-1216 Ethernet Adapter (rev 11)
Subsystem: Accton Technology Corporation EN2242 10/100 Ethernet Mini-PCI Card
Flags: medium devsel
I/O ports at <unassigned> [disabled]
Capabilities: [c0] Power Management version 2
Was kann ich tun, um die Karte korrekt einzubinden? Können Ports manuell kontrolliert und zugewiesen werden? Bitte alle Infos ausführlich. Ich habe keine Ahnung von Linux.
Matthias
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99