I solved my own problem....
I am a neophyte when it comes to LINUX. I do use it occasional for programming, etc..., but I never had to configure anything.
I have the iso I burnt to a CD, which I am trying to boot and run. I have WindowsXP installed on my first partition of my first drive. I have a Maxtor 200GB ATA 133 drive which is connected to an ATA PCI card. It does see my drives because I see them listed and their info.
When the system boots I type expert and see what is going on and I wrote down this info:
hde: pio
hde: host protected area => 1
hde: status timeout: {busy}
hde: drive not ready for command
hde: 398297088 sectors (203928 MB) w/ 1819KiB cache CHS = 155114/16/63
I get a similar display for hdf, too.
What is going on and what do I do? I did read some of the posts on here, but none of them were the exact same as my situation. I spent a few hours looking up the info myself. I tried some cheatcodes that I thought would work like nodma, noapic, acpi=off. Nothing works. I really could use the help.
Anyway, thanks for the help in advance.
I solved my own problem....
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Vintage SCCS Interface Microcomputer Magazine Pair 1976 IMSAI 8080 Altair 8800
$26.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00