I cannot say if this will work for you or not but you could check out:
Kmenu>System>DSL>DSL Configuration tool
Can't get network working, connecting via network card to external adsl modem/router. I tell to netcardconfig same addresses as in my other os wich works.
dmesg says NETDEV watchdog: eth0: transmit timed out
my networkcard is: PCI Realtek (irq 1
adsl modem: Telewell EA200
im running knoppix livecd ver. 3.2 (18.4.2003)
I cannot say if this will work for you or not but you could check out:
Kmenu>System>DSL>DSL Configuration tool
If you've been running Windows on this computer and have run any of the "security updates" for windows this year, see my posts
in this forum titled Evidence WinXP "security updates" may break Linux and Knoppix using NatSemi DP83815 stopped
working. There are also a pair of commands in these posts that might get you working again.
MITS Altair 680 Case Only LAST ONE LS3
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00