So I am considering the purchase of a banged up macbook as a fixer-upper. It has a broken monitor and there currently is not an operating system installed. I need to test it to make sure that it can boot up before handing over any money for it. My plan was to use the Knoppix live boot cd and a mini-dvi to rca adapter that connects to a small portable television. I have a macbook of my own so I am using that to test if my approach will work. Upon boot up Knoppix starts up just fine and the dvi adapter is auto-detected so it is getting a signal. But my little television displays three rows, each containing scrambled copies of the proper screen, without color, that slide almost like a vhs tape that is tracking incorrectly. Occasionally a "No Signal" message appears and then a second later it flashes back to the sliding rows. I am assuming that there is some setting I must change in the "Monitior Settings" to get the proper appearance. But I have no idea what that setting might be. Any thoughts / suggestions would be appreciated. Thanks.
Matt
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
Rare MITS Altair 8800 Short Course Documentation Binder with manuals
$299.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$74.95
MITS ALTAIR 8800 88-2SIO S-100 Reproduction Board
$35.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
Altair MSAI Douglas Electronics 11 DE Prototype Card S100 circuit board #AX44
$69.00