Hi,
I have a P3 Dell laptop without a hard disk (malfuction of controller?) which manages to run Knoppix 7.0.4 with only 128mb of ram. I thought it is because it recognised my PCMCIA slot 5gb hard disk and used it for a swap file, but it is not being shown as a drive, and I seem to remember drives should be recognised automatically? The drive is working, it is recognised by the winxp install disk, and from win on another laptop, but the machine won't boot from it.
Is there a way to use a PCMCIA hdd from Knoppix? Is it a driver issue, or a mounting issue?
MITS Altair 680 Case Only LAST ONE LS3
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99