Hi all, I often set up routers and other devices that start off with default IP addresses that aren't in the "normal" range of private addresses. For example, a Linksys WPG54G device has the default fixed address of 192.168.1.200, but my network has addresses on 192.168.0.* range with DHCP. So how to access the web configuration when you're on a "different" network? Easy peasy. Just launch a terminal, and type "sudo ifconfig 192.168.1.1 up" to assign yourself a address in the 192.168.1.* range. Then you should be able to "ping 192.168.1.200" and get a response. Now you can launch a web browser and do the web configuration on the router or other device. When you want to go back to your normal DHCP, just type "sudo ifconfig down" and wait until the icon on the notification area says "network disconnected", then "sudo ifconfig up" and you will get your DHCP assigned ip address back.
MITS Altair 680 Case Only LAST ONE LS3
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00