Hi,
Just a few notes here about the installation of Knoppix 7.2.0 on an old EEEPC 701 (512 Mo RAM, 4 Go SSD, 800x480 screen).
Works OK, wifi OK. But installation to hard disk (SSD in fact) was painful because of the restrictions and lack of configurability of KNOPPIX "0wn" script. For successful use of the "0wn" script I did the following:
* Modify /usr/share/0wn/0wn-partitioning so that fonction get_disks() only returns "/dev/sda" (the result normally includes /dev/sdc, which causes a bug on my machine because /dev/sdc is not available)
* Reduce swap size in function partition_whole_disk() in script /usr/share/0wn/0wn-partitioning
* Reduce SWAP_NEEDED value accordingly in script /usr/share/0wn/0wn-common
After this, the "0wn" script could run flawlessly and installation finished correctly. Last configuration was to set "xmodule=fbdev" in the boot command line, in order to get the 800x480 screen resolution working.
O.
MITS Altair 680 Case Only LAST ONE LS3
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99