This may help:
http://www.boot-disk.com/boot_priority.htm
I'm using KNOPPIX_V7.7.1DVD-2016-10-22-EN.
I boot using the DVD and run Install KNOPPIX to flash disk.
When I try to boot from the USB all I get is a blinking cursor...
I have a Active@Boot USB that works in the computer I'm using.
I do notice that my boot menu shows the Knoppix USB as 'USB-ZIP0 : SanDisk' under the 'Removable' section of the menu.
When I boot from my Active@Boot USB the boot menu show it as 'USB-HHD0 : USB DISK' under the 'Hard Disk' section of the menu.
Any help would be appreciated... where do I start to make this work
This may help:
http://www.boot-disk.com/boot_priority.htm
Thanks for the reply... I did check all the BIOS settings but, after using the same USB on some other computers, it seems to be something unique to the way some BIOS's treat the device descriptor.
I'm puzzled why one machine will see it as USB-ZIP0 and others as USB-HHD0. I'm going to look at the disk type byte(s) and see what (if any) difference there is between the boot-able USB created by Active@Boot and the one created by flash-knoppix. Can anyone point me to where the disk type byte(s) may (or what they should) be?
Another thing I'm going to do is create the USB on a machine that does see it as USB-HDD0...
MITS Altair 680 Case Only LAST ONE LS3
$500.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
Altair MSAI Douglas Electronics 11 DE Prototype Card S100 circuit board #AX44
$69.00