Hi,
I have a P3 Dell laptop without a hard disk (malfuction of controller?) which manages to run Knoppix 7.0.4 with only 128mb of ram. I thought it is because it recognised my PCMCIA slot 5gb hard disk and used it for a swap file, but it is not being shown as a drive, and I seem to remember drives should be recognised automatically? The drive is working, it is recognised by the winxp install disk, and from win on another laptop, but the machine won't boot from it.
Is there a way to use a PCMCIA hdd from Knoppix? Is it a driver issue, or a mounting issue?
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS ALTAIR 8800 88-2SIO S-100 Reproduction Board
$35.00
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
HyperWorks 2020 Suite for PC (Tool For Engineering Design, Simulation) 50Gb
$72.87