You need to reinstall and this time don't use IGNORE_CHECK=1.
Greetings,
I am very new to linux and recently installed the Knoppix 3.6 CD on a PC with success. So, I decided to install it on my laptop (HP Pavilion without a floppy drive) using the installer that comes with it. I used the IGNORE_CHECK=1 sudo knoppix-installer and when through the installation as I did with the PC. I chose the basic configuration and partitioned the whole hard drive for a single linux boot. Everything appeared to go well until it was time to remove the CD and reboot. I get the usual HP logo page and then I receive the following:
Hard disk boot sector invalid
Press 'H' to retry Hard Disk, any other key for floppy
Again, I don't have a floppy and selected "No" when it was offered during the installation.
What has happened and how do I get beyond this issue?
Thanks,
NEOMinds
You need to reinstall and this time don't use IGNORE_CHECK=1.
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
Vintage SCCS Interface Microcomputer Magazine Pair 1976 IMSAI 8080 Altair 8800
$26.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99