-
Using Knoppix 3.6 with a proxy server
I am wanting to start to use Knoppix to scan my NTFS partitions for virus' using F-Prot. This is from work so there is a proxy server that I must go through. I know the address and port, but whenever I input the info into Knoppix, once it is booted up, I use the "Install Software from disk" (this is Knoppix 3.6). From there I try to install F-Prot, my problem is that when it tries to get the program and updates from the FTP site, it can't. I have made sure that the FTP setting under the proxy server settings is correct and it still can't connect. It says something like "no tunnel" or "connection failed". Any help with this will be very helpful. Thanks.
-
Senior Member
registered user
from terminal screen :
sudo export http_proxy=http://myproxy.xxx.xxxortnumber
sudo export ftp_proxy=http://myproxy.xxx.xxxortnumber
and from this same terminal launch any script which has to know the proxysettings.
Hope this'll set you on the right track
-
Nada
That didn't work. I am sort of a begginer when it comes to Linux. Is there another way I can make this work and use the GUI front end for F-Prot?
-
Senior Member
registered user
Maybe you need to authenticate to the proxy in which case the above becomes:
export http_proxy=user:password@proxy_host:portnumber
Similar Threads
-
By X_ArchAngel in forum Networking
Replies: 0
Last Post: 03-03-2005, 09:25 PM
-
By jpkennedy79 in forum Networking
Replies: 0
Last Post: 01-19-2005, 02:49 PM
-
By MaldiGola in forum General Support
Replies: 1
Last Post: 09-10-2004, 03:45 AM
-
By Gustafus in forum General Support
Replies: 5
Last Post: 01-29-2003, 01:10 AM
-
By NBCthreat in forum General Support
Replies: 1
Last Post: 01-15-2003, 12:40 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
Vintage SCCS Interface Microcomputer Magazine Pair 1976 IMSAI 8080 Altair 8800
$26.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99