hello all,
i have recently installed knoppix onto my tecra 520cdt, it sports a 20gb HD ,160Mb, 166Mhz MMX CPU and DVD drive. The live CD enabled DMA, but then rebooting from the HD install the DMA has been turned off? any ideas where this should be enabled?
also when in the KDE desktop the HDA1 (8Gb) will not mount properly and shows read only, but my other partitions HDA3 (5GB) and HDA4 (5Gb) are accessible and RW is enabled BTW(HDA2 is my swap 2Gb)
any ideas?
i assume i edit the HDParm area? or in bootmisc.sh
thanks
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Vintage SCCS Interface Microcomputer Magazine Pair 1976 IMSAI 8080 Altair 8800
$26.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
VINTAGE DEC 1975 VOL 1 ISSUE 1 SCCS INTERFACE MAGAZINE MITS ALTAIR COVER & ADS
$359.99