Hi all,
I am new to the forum and here because I have been working on the same project for the past three days. Just today I learned of Knoppix, but I have done alot of research and I feel I have a good grasp on it.
Here's my problem: I purchased an Intel 6300 wifi card (from eBay thinking that I could save some money). Ofcourse the card has a PCI ID that is one digit off from passing the laptop's whitelist. I do however have another laptop without a whitelist that the card is currently in. Knoppix 6.7.0 boots without errors and detects the card (wlan0, I can connect to my wireless network). Yet ethool (root shell) is giving me problems. The two commands I need to use, "ethtool -e wlan0" and "ethtool -E wlan0..." give the error "Cannot get EEPROM data: Operation not supported".
What should I do? Any help would be greatly appreciated. Thanks in advance.
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
Vintage SCCS Interface Microcomputer Magazine Pair 1976 IMSAI 8080 Altair 8800
$26.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$64.95
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
1974 Early Microcomputers by MITS Altair 8800's Ed Roberts HP-9810 Mark-8 Scelbi
$55.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00
Altair MSAI Douglas Electronics 11 DE Prototype Card S100 circuit board #AX44
$69.00