Helllo there,
thanks to Knoppix and these forums I have a working installation of Debian. Very nice and quick it is too.
Some issues.
Query 1
Network card not starting automatically. However, after boot if I use netcardconf or ifup to start it, it then works fine. /etc/network/interfaces has the following apropriate lines
auto lo eth0
iface lo inet loopback
iface eth0 inet dhcp
Query 2
I have a Toshiba 6000 Satellite Pro laptop.
In all the Linuxes(?) I have put on it the keyboard repeat mode is too fast so that extra characters are always inserted. More of a problem in console. How do i slow this??
Query 3
Usually if I switch to console (CTRL-ALT-F1) from X, X crashes out and either dumps me at login manager or console prompt, depending on where it was started. Again this is not Knoppix specific or even machine specific. But it is highly annoying.
Thanks for any help in advance
Richard
PS Posted twice to get responses
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
New Unused S-100 Bus Edge Card Connector Vintage Altair Imsai Computer
$74.99
Rare Cromemco IOP Input Output Processor Card 1984 S-100 S100 Board Imsai Altair
$175.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
Rare Cromemco D+7A IO Card 1977 S-100 S100 Board Imsai Altair
$199.99
Cromemco 32K Bytesaver S-100 EPROM Programmer Board 1978 Altair IMSAI
$199.99
HyperWorks 2020 Suite for PC (Tool For Engineering Design, Simulation) 50Gb
$72.87
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00