I'm using Knoppix 3.3 and booting from cd. I have used it before on this comp and it works fine. Now though it'll stall while trying to auto config the devices. It tells me to check my bios. What would I need to check in bios?
A few miscellaneous questions:
I have a spare 5 gig hd an i'd like to run knoppix on that. What file system shoulD use? I'm have 2 hDs alreay anD I think my serial cable only allows the use of 2 hD. Is usually how it is? I'm scareD to partiton either of my Drives because I Don't want to lose the info alreay on them. AnD there's too much info on them to back it up.
Thanks again
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
Altair MITS 8800 CPU Parts Kit not IMSAI 8080 S100 (board NOT included)
$69.95
S-100 backplane motherboard bare PCB 9 slot (for Altair/IMSAI)
$30.00
Vintage The Age of Altair MITS Brochure with 1975 Price Guide
$225.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Altair MSAI Douglas Electronics 11 DE Prototype Card S100 circuit board #AX44
$69.00
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00