Why not read- and writable? I suppose you are using a "poor man's install.
First I boot knoppix as:
then I seeknoppix64 init 2 no3d fromhd="/dev/sdc5"
$ mount | grep mnt-system
/dev/sdc5 on /mnt-system type ext4 (rw,relatime,block_validity,delalloc,barrier,user_ xattr,acl)
$ blkid | grep sdc5
/dev/sdc5: LABEL="KNPX771" UUID="54e317fe-73cf-4b1c-8b1f-dfc9b708b68a" TYPE="ext2" PARTUUID="591ef660-03"
Why not read- and writable? I suppose you are using a "poor man's install.
OK, I (most probably wrongly) thought that partition used for a "poor man's install" would be read-only anyway
Say, you would like to define the regular user directory on the starting command prompt and you don't want anything to be ever written there
In fact, you would run knoppix without a hard drive at all and set up a user account after it started in case you would like to save anything. I would say a few files (access control + security) would be altered, just a few ... but the rest should be read-only
How do you do that?
Last edited by Albretch; 12-19-2016 at 08:03 PM.
In this case I wouldn't use a Live Linux as Knoppix with all his limitations. I would prefer for example Debian.
MITS Altair 8800 Computer Bamboo Reproduction Arduino Tested Working Assembled
$649.99
New Unused S-100 Bus Edge Card Connector Vintage Altair Imsai Computer
$74.99
Bare S100 CPU Replacement for ALTAIR 8800 IMSAI 8080 JAIR Single Board Computer
$42.00
Rare Cromemco IOP Input Output Processor Card 1984 S-100 S100 Board Imsai Altair
$175.00
MITS ALTAIR 8800 Original Vintage Microcomputer
$6000.00
MITS ALTAIR 8800 Original Vintage Microcomputer S-100 Buy It Now $5999
$5999.00
MITS ALTAIR 8800 Original Vintage Microcomputer with 14 boards - Buy It Now
$9500.00
Altair MITS 8800 CPU Card 8080A S-100 S100 replica IMSAI CP/M
$35.00
HyperWorks 2020 Suite for PC (Tool For Engineering Design, Simulation) 50Gb
$72.87
Vintage Altair 8088 CPU Wire Wrapped S100 Card w Mon EPROM circuit board #T71
$99.00